EasyManua.ls Logo

kozy heat SLAYTON-42S User Manual

kozy heat SLAYTON-42S
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
HUSSONG MANUFACTURING CO., INC.
INSTALLATION AND
OPERATION MANUAL
ͷ Do not store or use gasoline or other
ammable vapors and liquids in the vicinity
of this or any other appliance.
ͷ WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do
not use any phone in your building.
Leave the building immediately.
Immediately call your gas supplier from
a neighbors phone. Follow the gas
suppliers instructions.
If you cannot reach your gas supplier,
call the re department.
ͷ Installation and service must be performed
by a qualied installer, service agency or
the gas supplier.
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
This appliance may be installed in
an aftermarket, permanently located,
manufactured home (USA only) or mobile
home, where not prohibited by local codes.
This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with other
gases, unless a certied kit is used.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
English and French installation manuals are available through your
local dealer. Visit our website www.kozyheat.com.
Les manuels d’installation en français et en anglais sont disponibles
chez votre détaillant local. Visitez
www.kozyheat.com
.
DANGER
HOT GLASS WILL
CAUSE BURNS
DO NOT TOUCH GLASS
UNTIL COOLED
NEVER ALLOW CHILDREN
TO TOUCH GLASS
A barrier designed to reduce the risk of burns
from the hot viewing glass is provided with this
appliance and shall be installed for the protection
of children and other at-risk individuals.
Hussong Mfg. Co., Inc. • SLA-42S Report No: 0216GF036S • Rev. 7, December 2018
SLAYTON-42S
Model #SLA-42S
Direct Vent Linear Gas Fireplace

Table of Contents

Questions and Answers:

kozy heat SLAYTON-42S Specifications

General IconGeneral
Brandkozy heat
ModelSLAYTON-42S
CategoryIndoor Fireplace
LanguageEnglish

Summary

Homeowner Reference Information

Introduction

Appliance Certification

Details the appliance's certifications and standards compliance.

California Proposition 65 Warning

Warns about chemicals in the product known to cause cancer or birth defects.

Massachusetts Requirements

Outlines specific installation requirements for Massachusetts.

Carbon Monoxide Detector Installation

Details requirements for installing CO detectors and approved types.

Signage and Inspection Requirements

Covers identification plate requirements and inspector observations.

Venting System Manufacturer Requirements

Specifies requirements for manufacturer-provided or third-party vent systems.

Specifications

Heating Specifications

Provides input ratings, manifold pressures, and orifice sizes for gas types.

Altitude Adjustment

Explains derating requirements for installations at higher altitudes.

Appliance Dimensions

Shows detailed measurements and diagrams of the fireplace unit.

Safety Barrier Dimensions & Installation

Details barrier dimensions and step-by-step installation instructions.

Framing

Appliance Placement Considerations

Discusses safe and proper locations for installing the fireplace.

Stand-off Assembly and Installation

Guides the assembly and installation of stand-off brackets for clearance.

Clearances to Combustibles

Specifies minimum clearances required from combustible materials.

Wall Enclosure Rough Opening

Details the dimensions and requirements for the rough opening in the wall.

Floor Support and Protection

Outlines requirements for supporting the fireplace on the floor.

Recess Construction

Provides guidelines for constructing a recessed fireplace enclosure.

Vent Termination Framing

Explains how to frame openings for vent terminations.

Outdoor Covered Fireplace Installation

Details requirements for installing the fireplace in a covered outdoor area.

Heat Duct Kit Installation

Heat Duct Kit Components

Lists all parts included in the #970 heat duct kit.

Heat Duct Kit Specifications

Provides specifications, clearances, and vent run limits for the heat duct kit.

Attaching Heat Duct to Fireplace

Step-by-step instructions for connecting the heat duct to the fireplace.

Register Frame & Junction Box Installation

Guides the installation of the register frame and junction box.

Fan Assembly Installation & Wiring

Details how to install and wire the fan assembly.

Duct Pipe Installation

Instructions for running and securing the oval and round duct pipes.

Completing Heat Duct Installation

Final steps to complete the heat duct kit installation.

Heat Duct Kit Operation

Instructions on how to operate the heat duct fan and controls.

Heat Duct Kit Maintenance

Recommended maintenance procedures for the heat duct kit.

Facing and Finishing

Nailing Flange Assembly & Installation

Guides the assembly and installation of nailing flanges for framing.

Mantel & Facing Requirements

Specifies clearance requirements for mantels and facing materials.

Optional Trim Kit Installation

Instructions for installing the optional trim kit.

Gas Line Connection

Gas Conversion

Information on converting the appliance for different gas types.

Gas Line Installation

Provides instructions and safety precautions for installing the gas line.

Termination Locations

Vertical Vent Cap Termination

Specifies minimum height requirements for vertical vent cap placement.

Minimum Termination Clearances

Details required clearances for vent terminations in various locations.

Venting

Approved Vent Systems

Lists approved vent pipe systems and manufacturers for this appliance.

Venting Requirements

Outlines general requirements for combustion and ventilation air.

Elbows & Vent Restriction

Max elbows, vent restriction, and restrictor plate usage for flame adjustment.

Vertical Terminations

Details minimum and maximum vertical lengths for vent pipes.

Combination Venting

Provides guidelines for natural gas and propane combination venting configurations.

#800-1 Series Direct Vent Kit

Instructions for installing the #800-1 series direct vent termination kit.

Vent Heat Shield Installation

Guides the installation of vertical and horizontal vent heat shields.

Fireplace Set Up

Glass Frame Assembly

Instructions for removing and installing the glass frame assembly.

Light Kit Installation

Steps for installing the optional light kit.

Glass Media Installation

Procedures for installing different types of glass media.

Glass Media Dam Installation

How to install the glass media dam for proper air flow.

Control Board Removal & Installation

Detailed steps for removing and installing the control board.

Electrical Information

Electrical Specifications

Specifies electrical requirements and grounding standards.

Wiring Requirements

Outlines the electrical power and wiring needs for the IFC module.

Optional Fan Kit Installation

Instructions for installing the optional #SL42-028 fan kit.

Operating Instructions

General Safety Warnings

Crucial safety precautions to follow before operating the appliance.

Proflame 2 IFC Module Setup

Steps to set up the Proflame 2 IFC module and remote.

Initialize Control System

Procedure to initialize the control system for first-time use.

Reset for Manual Operation

How to reset the system to allow manual operation.

Automatic Safety Restart Feature

Explains the system's automatic safety shutdown and restart feature.

Backup Battery Operation

How the appliance operates during power outages using battery backup.

IFC Module Ignition Sequence

Details the ignition sequence steps and potential lock-out conditions.

Diagnostic Information

Provides information on error codes and low battery indicators.

Remote Control Operation

Comprehensive guide to using the remote control functions.

Temperature & Display Settings

How to change temperature units and lock the remote control.

Pilot Ignition & Appliance Control

Selecting pilot ignition mode and turning the appliance on/off.

Flame & Fan Speed Adjustment

Adjusting flame height, fan speed, and split flow for burners.

Thermostat & Light Control

Using thermostat modes and adjusting accent light intensity.

Remote Control Battery Status

Information on detecting and replacing low remote control batteries.

Adjustment

Pressure Testing

Procedures for testing inlet and manifold gas pressures.

Flame Appearance Adjustment

How to adjust venturi settings for optimal flame appearance.

Burner Venturi Adjustment

Adjusting air shutters for desired flame color and height.

Vent Restriction Adjustment

Using restrictor plates to manage draft and flame characteristics.

Troubleshooting

Pilot Will Not Light

Solutions for issues where the pilot fails to ignite.

Pilot Will Not Stay Lit

Troubleshooting steps if the pilot flame extinguishes.

Pilot Flame Always On

Diagnosing and resolving issues with a continuously lit pilot.

Main Burner Will Not Light

Steps to take if the main burner fails to ignite.

Pilot & Burner Extinguish During Operation

Troubleshooting for pilot and burner extinguishing during use.

Soot Appears on Glass

Causes and solutions for soot accumulation on the glass.

Blue Flame & Lifting Flame Issues

Addressing issues with blue flames or flames lifting off the burner.

No Reaction to Command

Diagnosing remote control communication or battery issues.

Maintenance

Firebox Maintenance

Procedures for cleaning and inspecting the firebox.

Fan Maintenance

Recommended maintenance for the fan assembly.

Vent System Maintenance

Inspection requirements for the vent system.

Glass Assembly Maintenance

Instructions for cleaning and inspecting the glass assembly.

Replacement Parts List

Limited Lifetime Warranty

Related product manuals