4-60 BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_04.fm
4 Putting into operation
Avoiding low-load engine operation
The running performance of the engine can be negatively affected if it
runs at high speed and at less than 20% of the load!
Effects:
- Operating temperature is not reached
- Increased lube oil consumption
- Lube oil in exhaust system, and therefore dirt in the engine
- Blue smoke in exhaust
► Run the engine in regular operation at loads of over 20 %.
Stopping the engine
To avoid overheating damage after shutting off the engine, do not turn it
off from full load operation!
► Let the engine run at idling speed for about 3 minutes so that the
temperature can stabilize, and then stop the engine.
In order to avoid damage to the starter, do not start the engine again
immediately after stopping it!
► Stop the engine.
► Wait at least 10 seconds before starting again.
1. Lower the loader unit fully.
2. Apply the parking brake.
3. Let the engine run at idling speed for about 3 minutes.
4. Turn the ignition key (preheating start switch 27) to position “0” and
remove it.
To Next Page
Loading...
