BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm 5-21
Operation 5
Reversing operation (changing travel direction)
Reversing operation (change of travel directon without stopping) is only
allowed in a secured job site for fast loading at low travel speed and lift
heights.
Injury hazard to persons in the danger zone!
Persons in the danger zone are possibly not seen and can be injured
during backward machine travel.
► Adjust the existing visual aids (for example the rearview mirrors)
correctly.
► Work particularly carefully when reversing the machine.
► Interrupt work immediately if persons enter the danger zone.
In the “Hare” speed range, changing direction during machine travel is
only possible below 14 kph (8.7 mph) and is only allowed in a secured job
site (for fast loading at low travel speed with a lowered loader unit).
1. Reduce the travel speed to below 14 kph (8.7 mph).
2. Select the travel direction with switch 87 on joystick.
- F = forward – symbol D/1 appears in the digital display.
- R = reverse – symbol D/2 appears in the digital display.
If the selection of the travel direction is not accepted (no function), this
means that the travel speed is higher than 14 kph (8.7 mph) or that push
button 88 (travelling drive – neutral position) has been pressed
unintentionally!
► Brake the machine.
► Select the travel direction again.
To Next Page
Loading...
