Kramer 8105

BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm 5-49
Operation 5
Putting the additional control circuit for tipping trailers into
operation
1. Lower the loader unit and apply the parking brake.
2. Stop the engine, but do not switch off ignition.
3. Release the pressure at the plug couplings
– see “Releasing the pressure at the plug couplings” on page 5-66.
4. Switch off the starter and remove the starting key.
5. Connect the hose pipe of the tipper to coupling connection H.
6. Turn changeover tap D to position 2 (rear).
7. Start the diesel engine.
8. Slide the lock in switch 89 downward and press the switch to position
A.
➥ The additional control circuit for the tipping trailer is activated.
9. Lower the tipping trailer: press push button 92 to position B.
10.Raise the tipping trailer: press push button 92 to position A.
Putting the additional control circuit for tipping trailers out of
operation
1. Stop the engine, but do not switch off ignition.
2. Release the pressure at the plug couplings
– see “Releasing the pressure at the plug couplings” on page 5-66.
3. Switch off the starter and remove the starting key.
4. Connect the hose pipe of the tipper to coupling connection H.
Fig. 150
A
B
92
89
D
1
2
H