5-70 BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm
5 Operation
Removing hydraulic lines from the 3rd control circuit
The attachment can tip over after lowering it to the ground!
Can cause serious injury or death.
► Uncouple all flexible lines from the attachment.
► Lower the attachment to the ground and ensure it cannot tip over.
1. Empty and tilt in the attachment completely.
2. Stop the engine, but do not switch off ignition.
3. Apply the parking brake.
4. Release the pressure in the hydraulic lines of the 3rd control circuit
– see “Releasing the pressure at the plug couplings” on page 5-66.
5. Clean the flat connector plugs E and F on the quickhitch facility
(Kramer) or on the attachment.
6. Remove the hose pipes A and B from the flat connector plugs on the
attachment (Kramer) or on the quickhitch facility and connect to the
open flat connector plugs.
➥ Flexible line A to plug coupling F
➥ Flexible line B to plug coupling E
7. Close the open flat connector plugs with the attached screwed nose
caps.
8. Start the engine and lower the attachment to the ground
– see “Lower the attachment” on page 5-62.
To Next Page
Loading...
