7-2 BA 35203_04 * 3.0 * 35203_04_07_Wartung.fm
7 Maintenance
Safety prop for loader unit (option)
Danger of crushing during maintenance work on a raised loader unit
that is not secured!
Can cause serious injury or death.
► Lower the loader unit to the ground during maintenance.
► If the machine is equipped with a safety support A (option), install it on
the extended lift cylinder and secure it with a locating pin C.
Installing the safety prop onto the lift cylinder
The safety support is located on the machine frame
(e.g. on the left at the access).
1. Park the machine on firm and level ground.
2. Empty and tilt in the attachment (bucket).
3. Raise the loader unit.
4. Apply the parking brake.
5. Stop the engine and remove the starting key.
6. Remove fastening screws B and the safety prop.
7. Remove lock pin C from the safety prop.
8. Slide safety prop A from below over the piston rod of the extended lift
cylinder and turn it 180°.
9. Install lock pin C and secure it with a safety pin.
10.Carefully lower the loader unit (without pressure) onto the safety prop.
Install the safety support as shown in Fig. 247 in order to avoid damage to
the piston rod and the safety support!
► Opening showing downward!
Before putting the machine into operation, remove the safety support from
the lift cylinder and fasten it in the pre-determined storage place!
To Next Page
Loading...
