7-66 BA 35203_04 * 3.0 * 35203_04_07_Wartung.fm
7 Maintenance
Removing the wheels
1. Park the machine on level and firm ground.
2. Lower the loader unit to the ground.
3. Apply the parking brake.
4. Stop the engine and remove the starting key.
5. Prevent the machine from rolling away (wheel chocks).
6. Loosen the wheel nuts a little of the wheel you want to remove.
7. Raise the machine only until the wheel can be moved freely.
8. Put a trestle under the axle tube ensuring stability.
9. Lower the machine onto the trestle.
10.Completely remove the wheel nuts.
11.Remove the wheel.
Mounting the wheels
1. Clean the flange surfaces of the wheels and axles.
2. Place the covering sleeves onto the wheel bolts.
3. Place the wheel onto the wheel bolts with a suitable means.
4. Remove the covering sleeves.
5. Fit all the wheel nuts and tighten them part-way.
6. Lower the raised axle.
7. Tighten the wheel nuts to the specified tightening torque
– see chapter 9 “Tightening torques” on page 9-17.
Retighten the wheel nuts after 10 operating hours to the specified
torque.
To Next Page
Loading...
