4-16 BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_01.fm
4 Putting into operation
Fastening the seat belt
1. Sit down on the operator seat.
2. Hold seat belt
E at buckle latch A and run it steadily over the hips to
buckle B.
3. Insert buckle latch A into buckle B until it engages audibly (pull test).
4. Tighten the seat belt by pulling at its end.
➥ The seat belt must not be twisted and must run tightly over the hips!
Unfastening the seat belt
1. Hold seat belt
E.
2. Press red button C on buckle B.
➥ Latch A is released from buckle B.
3. Slowly return the seat belt to the retractor.
Longer/shorter seat belt adjustment
1. Hold buckle latch A at a right angle to the seat belt and pull the seat
belt to the required length.
2. To shorten the lap belt, just pull the free end D of the belt.
When pulled slowly, the automatic seat belt offers full freedom of
movement. It locks however during abrupt braking.
The automatic seat belt may also lock when passing through potholes or
uneven terrain.
To Next Page
Loading...
