BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_01.fm 4-19
Putting into operation 4
Key-based immobilizer (option)
The drive interlock is integrated in the ignition lock and can only be
disabled with the blue ignition keys!
Scope of delivery:
• Immobilizer installed in the machine
• 2 x blue ignition keys (coded)
• 1 x red master key (for coding blue keys)
Coding the ignition keys
New personal keys are coded with the master key (red). This is why it
must be carefully stored outside the machine. The master key is only used
for coding new keys, and cannot be used for disabling the drive interlock.
1. Switch on the side marker lights
– see chapter 5 “Parking lights/low beam” on page 5-25.
2. Insert the master key in the ignition lock and turn it to position (2).
3. Turn and remove the master key from position (0) within 5 seconds.
4. Insert the key to be coded (blue) into the ignition lock, turn it to
position (2) and leave it in this position for at least 1 second.
➥ The key is registered as a valid key.
5. Remove the key.
➥ Step 4 can now be repeated for other keys to be coded.
➥ Coding can be performed for a maximum 10 keys.
➥ Coding is automatically stopped if no other key is detected within
15 seconds.
In order not to give any incorrect information to the electronics of the drive
interlock, the master key (red) has to be stored outside the machine after
coding new keys (not to be attached to the key chain of the key to be
coded).
The immobilizer has only one master key!
► The drive interlock must be replaced by an authorized service center if
the master key (red) is lost.
To Next Page
Loading...
