BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_01.fm 4-23
Putting into operation 4
Entering/changing the personal code
1. Disabe the drive interlock . To do this: enter the main code (6 digits)
and confirm it with the (*) touch button.
2. Turn the ignition key to position 1.
➥ The LED illuminates for 2 seconds.
3. Enter the 4, 5 or 6-digit new personal code and confirm with the (*) key
within 20 seconds after the LED has gone out.
➥ The LED flashes briefly.
4. Enter the new personal code again and confirm it with the (*) key.
➥ LED flashes 2x briefly. Then the LED lights for 2 seconds.
5. Turn the ignition key to the ZERO position and remove it as soon as
the LED goes out.
➥ The new personal code is now set and can be used for disabling the
immobilizer.
The personal code must be entered correctly twice consecutively
otherwise an error is indicated by means of a single flashing of the LED:
• Codes consisting of 3 and less, or of more than 6 digits are ignored by
the system.
• Simple codes (with identical or consecutive digits, for example
1, 2, 3, 4) are rejected by the system with four short acoustic signals.
• Entering a new personal codes replaces the previous code. A code
can be changed any time if the main code is known.
Enabling the immobilizer
1. Stop the engine.
2. Remove the starting key.
➥ The immobilizer is automatically enabled.
➥ The LED flashes.
To Next Page
Loading...
