Kramer MV-6 Quick Start Guide

Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your MV-6.
RS-232 Connection:
Use a 9-wire straight cable and connect only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5 to the RS-232 9-pin D-sub port on
your PC.
A null-modem adapter/connection is not required.
Step 5: Connect power
Connect the power cord to MV-6 and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
• For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the
terminal or in the User Manual.
• There are no operator serviceable parts inside the unit.
Warning:
• Use only the power cord that is supplied with the unit.
• Disconnect the power and unplug the unit from the wall before installing.
• Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
• To ensure continuous risk protection, replace fuses only according to the rating specified on the product label which located on the
bottom of the unit.
Step 6: Operate MV-6
Kramer MV-6 Controller Software:
RS-232 and Ethernet:
RS-232
Protocol 3000
Baud Rate:
115200
Data Bits:
8
Stop Bits:
1
Parity:
None
Command Format:
ASCII
Example (Output 1 to Input 2):
#V 2>1CR
Default Ethernet Parameters
IP Address:
192.168.1.39
Subnet mask:
255.255.255.0
Default gateway:
192.168.1.1
UDP Port #50000:
50000
TCP Port #5000:
5000
Maximum UDP Ports:
10
Maximum TCP Ports:
4
To achieve specified extension distances, use the recommended Kramer cables available at www.kramerav.com/product/MV-6.
Using third-party cables may cause damage!

Kramer MV-6 Specifications

General

Brand	Kramer
Model	MV-6
Category	Switch
Language	English