KRAMER: SIMPLE CREAT1VETECHNOLOGY
12
1 The EDID acquired is a weighted average of all the connected outputs. For example, if several displays with different
resolutions are connected to the outputs, the acquired EDID supports all the resolutions, as well as other parameters included
in the
EDID
To acquire or change the EDID of a new output display from:
• One output, see section
• The default EDID, see section
• Several connected outputs, see section
6.4.1 Acquiring I Changing the EDID from One Output
To acquire or change the EDID of one of the output displays:
l.
Connect the power supply.
2. Connect the new output display device.
3. Press the ED
ill
SELECT button, enter the One output mode as defined in
-'-"'~"', and set to the connected output.
The appropriate OUTPUT STATUS LED flashes, indicating that that
output channel is selected.
Press the EDID
SELECT button to
select the required
output. The selected
output flashes
The output
LEDsflash
Auto-mix
Press the EDID
SELECT button once
Default
Press the EDID
SELECT button once
again after selecting
output 4.
The LEDS flash
The selected
output LED
flashes
One Output
You can acquire the EDID from:
• One Output (the selected output LED flashes)
• The Default EDID (all the output LEDs flash)
• Several Connected Outputs, the Auto-mix Model (the output
LEDs flash in sequence)
To cycle between the different modes (One Output, Default and Auto-mix),
as defined in press the EDID SELECT button
Table
2:
The EDID Modes
6.4 Using the EDIDButtons
Using the VM-24H
To Next Page
Loading...
Need help?
General
