EasyManua.ls Logo

Kramer VM-2HDT - Operating the VM-4 HDT, VM-3 HDT and VM-2 HDT; IR and RS-232 Signal Routing

Kramer VM-2HDT
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Kramer Electronics Ltd.
VM‑4HDT, VM‑3HDT, VM‑2HDT – Operating the VM‑4HDT, VM‑3HDT and VM‑2HDT
9
Operating the VM‑4HDT,
VM‑3HDT and VM‑2HDT
This section describes the following functions
• IR and RS-232 Signal Routing on page 9.
• Acquiring an EDID on page 12.
IR and RS-232 Signal Routing
The VM‑4HDT can send or receive IR and RS-232 commands via the four HDBT output
ports.
Each signal can pass commands from the VM‑4HDT to a single output, several outputs or all
of the outputs or the other way around, from the output/s to the VM‑4HDT.
The IR/RS-232 signal routing is enabled via the SETUP DIP-switches (see Setting the
DIP-Switches on page 9).
Setting the DIP-Switches
This section defines the SETUP DIP-Switches:
Figure 7: VM‑4HDT DIP-Switches
Output #
IR Routing is
enabled when:
RS-232 Routing is
enabled when:
OUT 1
DIP 1 – OFF
DIP 5 – OFF
OUT 2
DIP 2 – OFF
DIP 6 – OFF
OUT 3
DIP 3 – OFF
DIP 7 – OFF
OUT 4
DIP 4 – OFF
DIP 8 – OFF