Kramer VP-434

Connecting the VP-434 Component / UXGA HDMI Scaler
9
5.1 Connecting the Contact Closure Remote Control PINs
The contact closure pins operate in a similar way to the Input selector button.
Using the contact closure remote control you can select the COMP or the
UXGA input. To do so, temporarily connect the required input
1
pin on the
REMOTE terminal block connector to the GND (Ground) pin, as Figure 3
illustrates.
DO NOT connect more than one PIN to the GND PIN at the same time
To select COMP,
connect the
COMP PIN to the
GND PIN
To select UXGA,
connect the
UXGA PIN to the
GND PIN
Figure 3: Connecting the Contact Closure Remote Control PINs
1 COMP or UXGA