5 Connecting the VP-434 Component / UXGA HDMI Scaler
To connect
1
your VP-434, as illustrated in the example in Figure 2, do the
following
2
:
1. Connect a component video source (for example, a DVD player) to the
COMP In Y, Pb, Pr, RCA connectors, and to the COMP In L and R audio
RCA connectors.
2. Connect a computer graphics source to the UXGA In 15-pin HD computer
graphics video connector, and to the UXGA In audio 3.5mm mini jack
connector.
3. Connect the HDMI Out connector to an HDMI acceptor (for example, a
plasma display).
4. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in Figure 2).
1 You do not have to connect all the inputs, connect only those that are required
2 Switch OFF the power on each device before connecting it to your VP-434. After connecting your VP-434, switch on its
power and then switch on the power on each device
To Next Page
Loading...
