6 Connecting the VP-725xl Presentation Switcher / Scaler
This section describes how to connect the VP-725xl. In particular, how to
connect the:
• VP-725xl rear panel (see section
6.1)
• Interlaced and progressive RGBS and RGsB inputs (see section
6.2)
• PC (see section
6.3)
• Ethernet port (see section
6.4)
Using the VP-725xl you can select any one of the 21 inputs and scale that
input to up to three scaled outputs (at the identical resolution).
6.1 Connecting the VP-725xl
To connect the VP-725xl, connect the following
1
to the rear panel, as the
example in
Figure 3 illustrates:
1. Connect one or more of the following video sources:
Up to four UXGA graphics sources (for example, computers) to the
15-pin HD input connectors
2
Up to four composite video sources (for example, DVD players) to the
BNC input connectors
Up to four s-Video sources to the 4-pin input connectors (not
illustrated in
Figure 3)
Up to four component video
3
(sometimes called YUV, or Y, B-Y,
R-Y, or Y, Pb/Cb, Pr/Cr) sources or four RGB sources to the four sets
of 3 BNC connectors, G/Y, B/Pb, and R/Pr.
Up to four HDMI sources (for example, DVD players) to the HDMI
connectors
2. Connect the CV OUT BNC connector, and the UXGA OUT 15-pin HD
connector to the respective video inputs on the projector.
3. Connect the HDMI connector to an LCD display.
4. Connect the COMP OUTPUT BNC connectors: G/Y, B/Pb, and R/Pr to
the respective component video inputs on the LCD monitor.
1 Switch OFF the power on each device before connecting it to your VP-725xl. After connecting your VP-725xl, switch on its
power and then switch on the power on each device
2 These connectors also accept interlaced and progressive RGBS and RGsB signals (see
Table 3)
3 For example, an HDTV satellite receiver to COMP IN 1 and an RGB camera connected to COMP IN 4
To Next Page
Loading...
