VS-88HDCPxl - Operating the VS-88HDCPxl 8x8 DVI Matrix Switcher
6.3 Storing and Recalling a Setup
You can use the STO and RCL buttons to store up to 12 setups and then recall
them as illustrated in Figure 4.
IN 1 is used for setup number 1 and OUT 1 is used for setup number 9.
Figure 4: SELECTOR Buttons
The gray numbers (1 to 16) in Figure 4 that illustrate the corresponding
store/recall configuration numbers are for the purpose of illustration
only and do not actually appear on the buttons.
To store a setup (for example, to preset 10):
1. Configure the switching as required for the preset
2. Press the STO button.
The STO button flashes.
3. Select an OUT or IN SELECT button to store the machine setup (for
example, OUT 2 for preset 10).
4. Press the STO button to store the current setup.
In this example, the OUT 2 button stores the setup.
Press the STO button within 10 seconds as the store operation times out automatically
after this period.
To recall a setup (for example, from preset 10):
1. Press the RCL button.
The RCL button flashes.
2. Press the relevant OUT or IN button that stored the setup.
In this example, press OUT 2 for preset 10.
3. Press the RCL button to recall the stored setup.
To Next Page
Loading...
