Kramer VW-9

Kramer Electronics Ltd.
VW-9 – Operating and Controlling VW-9
13
Menu Item
Function
INPUT 1 – INPUT 4
Connect the speaker or amplifier to the stereo audio terminal block
connectors to VW-9 via the stereo audio cable.
The multi-viewer aspect ratio is set.
To configure the color settings:
1. On the front panel press MENU. The menu shows.
2. Select MULTI-VIEWER > COLOR SETTING press Enter and define the color setting
parameters based on the information in the following table:
Menu Item
Function
Brightness
Adjust Brightness value between 0 ~ 100.
Contrast
Adjust Contract value between 0 ~ 100.
Hue
Adjust Hue value between 0 ~ 100.
Saturation
Adjust Saturation value between 0 ~ 100.
The multi-viewer color setting is configured.
To configure the layout settings:
1. On the front panel press MENU. The menu shows.
2. Select MULTI-VIEWER > LAYOUT SETTING press Enter and define the layout setting
parameters based on the information in the following table:
Menu Item
Function
1-3 x PiP
Sets the multi-viewer mode to present 1, 2, or, 3 PiP windows over a
parent picture in the video wall.
Quad Split
Sets the source to output for each monitor. Set up each monitor 1, 2, 3, 4
individually.
Custom 1-7
Set the position and size of the windows of each custom screen layout
from Custom1 to Custom 7.
Single Picture
The video of one source is only presented over the video wall.
The multi-viewer layout settings are configured.
To set the video source:
1. On the front panel press MENU. The menu shows.
2. Select MULTI-VIEWER > VIDEO SOURCE press Enter and define the video source
parameters based on the information in the following table:
Menu Item
Function
WIN A
INPUT 1-4.
WIN B
INPUT 1-4.
WIN C
INPUT 1-4.
WIN D
INPUT 1-4.
The multi-viewer video source is set.