Kramer VW-9

Kramer Electronics Ltd.
VW-9 – Operating and Controlling VW-9
14
To set the Unit ID source:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > UNIT ID press Enter and set the unit’s ID parameters based on the
information in the following table:
Menu Item
Function
Unit ID
Indicate the ID of the unit. ID ranges between 0-100.
The Unit’s ID is set.
To view the MAC address:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > MAC ADDRESS press Enter.
The MAC address shows.
To configure the RCL/STO:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > RECALL/STORE press Enter and set the unit’s ID parameters based
on the information in the following table:
Menu Item
Function
STO
(Store)
Press, followed by an Input button (1 to 4), to save the current wall
configuration.
RCL
(Recall)
Press, followed by an Input button (1 to 4), to recall a pre-saved wall
configuration.
The RCL and STO are configured.
To configure the HDCP setting:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > HDCP SETTING press Enter and set the HDCP setting parameters
based on the information in the following table:
Menu Item
Function
Input 1
ON/OFF
Set HDCP support on HDMI 1 to HDMI 4 inputs to ON (default) or
OFF. Note that: 1. HDCP must be enabled (ON) to support HDCP
encrypted sources. 2. Sources such as Mac computers always
encrypt their outputs when detecting that the sink supports HDCP.
If the content does not require HDCP, you can prevent these
sources from encrypting by disabling (OFF) HDCP on the input.
Input 2
ON/OFF
Input 3
ON/OFF
Input 4
ON/OFF
The HDCP settings are configured.