Kramer VW-9

Kramer Electronics Ltd.
VW-9 – Operating and Controlling VW-9
15
To configure the network settings:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > NETWORK SETTING press Enter and set the network setting
parameters based on the information in the following table:
Menu Item
Function
Ethernet Type
Select Ethernet type STATIC or DHCP.
IP Address
Indicates the systems current IP address.
For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to
192.168.1.255 (excluding 192.168.1.39.
Default: 192:168:001:039.
Mask
255:255:255:000
Gateway
000:000:000:000
The network settings are configured.
To configure the OSD setting:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > OSD SETTING, press Enter and set the OSD setting parameters
based on the information in the following table:
Menu Item
Function
H Offset
0-100
V Offset
0-100
Transparency
0-4
IDENT. Timeout
OFF/5-50
MENU. Timeout
OFF/5-50
INFO. Timeout
OFF/5-50
INFO. Display
ON/OFF
The OSD settings are configured.
To use the factory default:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > FACTORY DEFAULT press Enter and set the factory default
parameters based on the information in the following table:
Menu Item
Function
ON
Use the factory default settings.
OFF
Do not use the factory default settings.
If “on” is selected, the device is reset to its factory default settings.