Kramer VW-9

Kramer Electronics Ltd.
VW-9 – Operating and Controlling VW-9
17
2. Click Change Adapter Settings.
3. Highlight the network adapter you want to use to connect to the device and click Change
settings of this connection.
The Local Area Connection Properties window for the selected network adapter shows
as shown in Figure 5.
Figure 5: Local Area Connection Properties Window
4. Highlight either Internet Protocol Version 6 (TCP/IPv6) or Internet Protocol Version 4
(TCP/IPv4), which is based on the requirements of your IT system.
5. Click Properties.
The Internet Protocol Properties window (specific to your IT system) shows as in Figure
6 or Figure 7.
Figure 6: Internet Protocol Version 4 Properties Window