Kramer VW-9 - Page 48

Kramer Electronics Ltd.
VW-9 – Protocol 3000
46
Function
Description
Syntax
Parameters/Attributes
Example
MACH-NUM
Set machine number.
Some devices do not
set the new machine
number until the device is
restarted.
Some devices can
change the machine
number only from DIP-
switches.
COMMAND
#MACH-NUMmachine_id<CR>
FEEDBACK
~nn@MACH-NUMmachine_id<CR><LF>
machine_id – New device machine
number (1 to 99)
Set machine number ID
to 5:
#MACH-NUM5<CR>
MACH-NUM?
Get machine number.
Some devices do not
set the new machine
number until the device is
restarted.
Some devices can
change the machine
number only from DIP-
switches.
COMMAND
#MACH-NUM? <CR>
FEEDBACK
~nn@MACH-NUMmachine_id<CR><LF>
machine_id – New device machine
number (1 to 99)
Get machine number:
#MACH-NUM? <CR>
MODEL?
Get device model.
COMMAND
#MODEL?<CR>
FEEDBACK
~nn@MODELmodel_name<CR><LF>
model_name – String of up to 19 printable
ASCII chars
Get the device model:
#MODEL?<CR>
MUTE
Set audio mute.
COMMAND
#MUTEout_index,mute_mode<CR>
FEEDBACK
~nn@MUTEout_index,mute_mode<CR><LF>
out_index – Number that indicates the
specific output:
1 – Output 1
2 –Output 2
3 – Output 3
4 – Output 4
5– Output 5
6 – Output 6
7 – Output 7
8 – Output 8
9 – Output 9
10 – Output 10
* – All
mute_mode – On/Off
0 – Off
1 – On
Set Output 1 to mute:
#MUTE1,1<CR>
MUTE?
Get audio mute.
COMMAND
#MUTE?out_index<CR>
FEEDBACK
~nn@MUTEout_index,mute_mode<CR><LF>
out_index – Number that indicates the
specific output:
1 – Output 1
2 –Output 2
3 – Output 3
4 – Output 4
5– Output 5
6 – Output 6
7 – Output 7
8 – Output 8
9 – Output 9
10 – Output 10
* – All
mute_mode – On/Off
0 – Off
1 – On
Get mute status of
output 1
#MUTE1?<CR>
MUTE-ANA
Set analog output
settings.
COMMAND
#MUTE-ANAchannel,mute_mode<CR>
FEEDBACK
~nn@MUTE-ANAchannel,mute_mode<CR><LF>
channel – * (All)
mute_mode – 0 – off unmute, 1 – on mute
Set analog output
settings:
#MUTE-ANA*,1<CR>
MUTE-ANA?
Get analog output
settings.
COMMAND
#MUTE-ANA?channel<CR>
FEEDBACK
~nn@MUTE-ANAchannel,mute_mode<CR><LF>
channel – * (All)
mute_mode – 0 – off unmute, 1 – on mute
Get analog output
settings:
#MUTE<CR>