60
ClimTec
®
The optionally available outriggers are designed
to provide additional support to the ClimTec
®
and make it safer.
– Attach the outrigger’s two clamps to the
ClimTec
®
and tighten them.
– Position the outriggers as shown in the
drawing.
– The outriggers have to fully rest on the
ground.
If necessary, put break-proof supports under-
neath the outriggers to make sure they pro-
perly rest on the ground.
4.7 Fitting the outriggers (accessory)
Art.-No. 714039
ClimTec
®
has to be protected from tipping
over with either ballast weights (accessory)
or outriggers (accessory) depending on its
height. Stabilisers are not a substitute for
ballast weights or outriggers.
The number of ballast weights or outriggers
required are shown in the table below.
4.6 Attaching ballast to the ClimTec
®
Art.-No. 704306
To Next Page
Loading...
