64
ClimTec
®
4.8 Attaching the ClimTec
®
to a wall
When using the ClimTec
®
at a wall, it can be fastened to the wall with
the stabilisers.
• To do so, the stabilisers have to be attached to the tower at a height
of 2 metres.
• Take note of the table for ballast weight requirements when
attaching the tower to a wall (63).
• Insert the hook into a ring bolt fastened to the wall.
• Secure the stabilisers with the locking bolts.
• Arrest the stabilisers’ sliding bolt with a locking pin.
4.9 Labelling after assembly
Once the ClimTec
®
has been assembled or reconfigured, it has to be
provided with a label that has to be clearly legible from the ground
and feature the following minimum information:
– Name and contact details of the person in charge
– Whether or not the ClimTec
®
is ready for use
– The load class and the evenly distributed load
– Whether the ClimTec
®
has been configured for indoor use only
– The date it was erected
In some countries, providing this information/label is a legal requirement!
To Next Page
Loading...
