4-
9
Getting to Know Your K3 System
Use A & B Spacing
On 1-3/4” to 2-3/4”
Material
Use A & C Spacing
On 2-3/4” to 3-3/4”
Material
Choosing the Correct 2-Hole Spacing
Spacing pocket holes across the width of a workpiece is important in maximizing the
strength of a joint. When framing most woodworking projects, it is recommended
to place two pocket holes across the width of a rail to keep the workpiece from
twisting once it has been assembled. The patented three-drill guide fixed spacing of
the Kreg Jig
®
Drill Guide Block makes it extremely easy to place two pocket holes in
a workpiece without having to unclamp and move the workpiece to drill the second
hole. A real timesaver when working with a variety of wood widths. We recommend
using the drill guide spacings indicated below for each rail width. For very wide pieces
such as panels, we recommend placing a pocket hole every 6-8 inches across the
length of the panel. Use any of the three drill guides to form the pocket on panels.
Use B & C Spacing
On 1-1/4” to 1-3/4”
Material
Fig. 9A
Fig. 9B
Fig. 9C
To Next Page
Loading...
