5
Assembly/Setup (continued)
c. Slide the Plug Cutter Stop Collar (C) onto the Plug Cutter Bit (B) until
it rests on the bit shoulder. Tighten the Plug Cutter Stop Collar (C) set
screw with the hex wrench (D).
Note Kreg recommends usng a corded drill for drilling pocket hole plugs.
Higher speeds will produce better quality pocket hole plugs, but also increase
the heat produced, so it may be necessary to adjust your production rate to
allow time for the bit to cool.
C
D
B
To Next Page
Loading...
