Kreg Mini MKJ - Screw Penetration by Jig Setting

Screw Penetration by Jig Setting
This chart illustrates the amount of screw penetration that will occur into the
second workpiece in a given position of any Kreg Jig
®
.
**
Always test in scrap material before driving final screws)**
1717
1717
17
2”
screw
1-1/2”
screw
2-1/2”
screw
1" Screw
Figure
(27)
1/4
3/4
1-1/4
1-1/2” Setting - (1-1/2” material setting of any Kreg Jig
®
)
Depth Collar set to 4-1/4” from the step of the drill bit.
1-1/4”
screw
1-1/2”
screw
1”
screw
2”
screw
2-1/2”
screw
Figure
(26)
3/8
5/8
7/8
1-3/8
1-7/8
3/4” Setting - (3/4” material setting of any Kreg Jig
®
)
Depth Collar set to 3-1/2” from the step of the drill bit.
1-1/4”
screw
1-1/2”
screw
1”
screw
2”
screw
2-1/2”
screw
Figure
(25)
7/16
3/4
1
1-1/2
2
1/2” Setting - (1/2” material setting of any Kreg Jig
®
)
Depth Collar set to 3-5/16” from the step of the drill bit.