To Next PageTo Next Page
Need help?Do you have a question about the Krick ANTARES and is the answer not in the manual?
General| Category | Toy |
|---|---|
| Scale | 1:20 |
| Beam | 180 mm |
| Type | Model yacht |
| Material | Wood |
Assemble and prepare the boat stand for stability and water protection.
Instructions for hull marking, rudder tube, and stern tube placement.
Steps for assembling the rudder and fitting rudder tubes into the hull.
Further hull modifications and preparations, including rudder installation.
Steps for preparing the motor for installation.
Procedure for installing ballast into the keel for weight and balance.
Attaching deck support bars and auxiliary rafters to the hull.
Positioning and affixing the servo board within the hull structure.
Covering the building board and preparing deck parts for assembly.
Gluing bulkheads into the recesses of the deck for structural integrity.
Assembling the base frame for the removable superstructures.
Attaching companionway parts, skylight frames, and roof sections.
Assembling the mast, caps, and spreader for the model.
Preparing and assembling the main boom and gaff sail boom.
Assembling and attaching yardarm fittings and masthead components.
Mounting the traveller and securing eyebolts on the deck.
Creating and installing cleats and the pin rail on the deck.
Assembling the steering wheel and fitting the cockpit grating.
Preparing and placing the toe rails on the model's deck.
Attaching light board components and shroud spreader parts.
Assembling the anchor winch and mounting the flagpole.
General concepts and initial steps for rigging the model.
Detailed steps for installing mainsail and headsail winches.
Steps for attaching the mainsail to the mast and boom.
Preparing and attaching the jib, foresail, and topsail.
Mounting the anchor, winch, flagpole, light board, and navigation lights.
Fitting the servo for the rudder linkage and connecting rods.
