To Next PageTo Next Page
Need help?Do you have a question about the Krick COMTESSE and is the answer not in the manual?
Details necessary glues, fillers, and paints for assembling the model, including specific order numbers.
Lists essential tools like knives, drills, sandpaper, and side cutters for model construction.
Lists necessary accessories like fitting sets, servos, and winches not included in the kit.
Lists optional accessories such as wing keels or propulsion sets for the model.
Specifies the required remote control system for operating the model.
Provides overarching guidelines and advice for the model building process.
Lists key dimensions and specifications of the Comtesse model.
Instructions for assembling the boat stand using parts 0.1 to 0.3.
Steps for preparing the hull, drilling deck holes, and fitting reinforcement boards.
Guidance on installing the rudder bearing, support, and linkage using parts 2.1 to 2.8.
Instructions for preparing and installing the RC board and filling the ballast.
Steps for trimming, fitting, and securing the cockpit and sliding hatch.
Instructions for assembling the mast, including drill holes, hangers, and boom fittings.
Details on constructing and attaching the main and foresail booms.
Guide to reinforcing the mainsail and attaching luff sliders.
Instructions for preparing the foresail, attaching forestay, and rigging.
Steps for manufacturing and attaching bow and stern pulpits and railings.
Guide to attaching railings, stanchions, and the bathing ladder.
Instructions for installing steering column, wheel, compass, and companionway.
Explains basic sailing terminology and refers to diagram "12".
Guidance for the initial boat test runs in calm water with constant wind.
Advice on trimming sails for optimal performance in various wind conditions.
Instructions for installing an optional electric drive set, including component details.
Comprehensive list of all parts included in the kit, with material, dimensions, and notes.
General
