Kroeplin C - Series - Preparing to Use the Gage; Changing the Battery

30
I
To open the battery cover (H) loosen the screws (I) by using the screwdriver provided and insert
the batteries.
Close the battery cover (H) after changing the batteries and tighten the screws (I).
 Insert the battery ensuring correct polarity!
 The batteries provided are not rechargeable!
 Battery type: 2x 1,5V Micro AAA / MN2400 / LR03
(particularly: DURACELL Plus)
 Close battery (H) cover carefully and pay attention to cleanness!
 If the measuring instrument is not used for more than 3 months the
batteries must be removed, as a leakage of the battery could cause
damage to the instrument.
If LOW-BATT (15) appears in the display a change of the battery is urgently
necessary.
Switching on:
1x short
Press and release „ON/<0>“ key
Switching off:
1x long
Press and hold „ON/<0>“ key (>2s)
Preparing to use the gage / Changing the battery
H