Need help?Do you have a question about the KROHNE CORIMASS MFM 4085 K/F and is the answer not in the manual?
General| Measurement Principle | Coriolis |
|---|---|
| Accuracy | ±0.1% of rate |
| Repeatability | ±0.05% of rate |
| Temperature Range | -50°C to +200°C |
| Output Signal | 4…20 mA, pulse, frequency |
| Communication Protocols | HART, FOUNDATION Fieldbus, PROFIBUS PA |
| Materials | Stainless steel, Hastelloy |
| Housing Material | Aluminium, stainless steel |
| Ingress Protection | IP67 |
| Process Connections | Flange, threaded |
Covers the initial installation and start-up procedures for the flowmeter.
Details the operation and functions of the MFC 085 signal converter.
Details the process of installing the flow meter into the pipeline system.
Covers the electrical connections and setup required for the flow meter.
Provides specific recommendations for installing the flow meter correctly.
Outlines the steps for initial start-up and configuration of the meter.
Explains how to operate and interact with the signal converter.
Guides users through common service tasks and troubleshooting steps.
Details the procedure for adjusting the zero point for accurate measurements.
Step-by-step guide to accessing the programming mode of the converter.
Explains how to perform zero point adjustment for accurate measurements.
How to program the current output for different measurement values.
How to configure the frequency and pulse outputs for measurement values.
How to configure the process alarm output for various states.
How to set up and use the binary control input for remote functions.
How to configure system control functions based on process conditions.
How to perform density calibration for optimal measurement accuracy.
Procedure for setting the high calibration point for density adjustment.
How to enable or disable custody transfer protection for data integrity.
How to set primary head type and tube parameters (CF1-CF5).
Information on using the meter in hazardous area applications.
Step-by-step instructions for replacing the converter electronics.
Identifies common operational errors and their causes/remedies.
A table to help diagnose faults based on symptoms and causes.
Procedures for checking the primary head's sensors and components.
To Next Page