krom schroeder MPT 700 User Manual

MPT 700
12
2.2.3.1 Selection of parameters
• All the parameters can be checked while the unit is in service without any effect
on operation.
• To check a parameter, select the parameter required using the left half of the
keypad.
⇒ The value of the parameter will then appear on the four-digit display in the
valid unit.
2.2.3.2 Changing parameters
• It is only possible to change parameters if the current equipment code is 0 or
the correct equipment code is entered (see parameter 87).
• Select the parameter which you wish to change using the keypad.
• The current value of the parameter will then appear on the four-digit display.
• You can increase or reduce the value using the right half of the keypad.
• If you select another parameter, the value which you have entered will be stored
in interim memory, but will not yet be effective.
• Changed parameters only become effective when the unit is switched back to
NORMAL OPERATION (parameters 0 to 4).

krom schroeder MPT 700 Specifications

General

Brand	krom schroeder
Model	MPT 700
Category	Control Unit
Language	English