kromo gr300 - 4 Machine Programming; Parameter Selection; Parameter Programming

EN
page 32
INSTALLER SECTION
4. MACHINE PROGRAMMING
The following is necessary to access programming:
• simultaneously press keys “A” and “B”, making sure to press key “B” just a little before,
for about 5 seconds after which the message “Key” shall be displayed;
• set the password parameter at “15” using keys “⇑” “⇓”;
• conrm the password by pressing key “A”; if the password is correct parameter access is
granted, if it is incorrect the message “Key Err” shall be displayed for about 4 seconds.
Note: to enter programming the machine must not be washing; if you try to enter program-
ming during washing, the message (no Pr) will be displayed and the dishwasher will continue
the cycle.
The machine will automatically exit programming if no key is pressed for about 20 seconds.
Note: to reset the display, turn off the general wall switch for 10 seconds, and then
turn the main wall switch on again.
4.1 Parameter selection
Once parameter selection is accessed the message “Pr” shall be displa A” repeatedly to
dene the parameter “P” number (P1, P2, … P20).
It is now possible to:
• modify the parameter value with the “⇑” “⇓” keys;
• conrm the value or proceed to subsequent parameter programming by pressing key
“A”;
• return to parameter selection without modifying data by pressing key “B”.
4.2 Parameter programming
Once parameter programming is accessed the message “P” shall be displayed as well as
the blinking parameter number followed by the parameter value.
It is now possible to:
• modify the parameter value with the “⇑” “⇓” keys;
• conrm the value or proceed to subsequent parameter programming by pressing key
“A”;
• return to parameter selection without modifying data by pressing key “B”.
The following parameters can be modied (see table):