Krone Comprima V 150 - Page 365

Terminal error messages 8
Faults of the electrics/electronics 8.1
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en 83
Possible cause Remedy
FMI 4: There is a cable break/short circuit, general error or undervoltage.
There is a cable break or
short circuit.
 Note down the error number on the FMI and contact the
service partner.
521118-
Low
Voltage group (UB2) is switched off.
Possible cause Remedy
FMI 11: The error cause is unknown.
The supply voltage of the
sensors could not be activ-
ated.
 Note the error number and the FMI. Then contact the
dealer.
522005-
Universal shaft
Possible cause Remedy
FMI 0: The universal shaft is rotating more quickly than permitted.
The set rotational speed of the
PTO shaft that drives the uni-
versal shaft is too high.
 Check the rotational speed of the PTO shaft set at the
tractor. Make sure the rotational speed is not higher than
540 rpm.
FMI 2: The universal shaft is rotating in “road mode”.
The PTO shaft is switched off
in road mode.
 Switch off the PTO shaft in road mode.
522010-
Blade cassette, for the “Hydraulic blade group control system” version
Possible cause Remedy
FMI 7: The blade cassette signals an error.
The blade cassette is not
closed.
 Swing in the blade cassette using the tractor hydraulics.
522011-
Blade cassette, for the “Hydraulic blade group control system” version
Possible cause Remedy
FMI 7: The blade cassette signals an error.
The blade preselection has
been changed.
 Swing out the blade cassette using the tractor hydraulics.
522012-
OFF
Blade cassette
Possible cause Remedy
FMI 7: The blade cassette signals an error.
The blade cassette is not
closed.
 Close the blade cassette using the tractor hydraulics.
The sensorB08 "Blade cas-
sette up" is defective or has
been incorrectly set.
 Check and adjust the sensorB08 "Blade cassette up", refer
to page61.