Krone Comprima V 150 - Page 371

Terminal error messages 8
Faults of the electrics/electronics 8.1
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en 89
Possible cause Remedy
FMI 0: There is a filling problem. The round bale in the bale chamber is too small on the left-
hand side.
Extremely uneven filling of the
bale chamber. More crops
were fed in on the right side
than on the left side.
 Fill the bale chamber more evenly.
 Drive more slowly at the end of the round bale.
 Check and adjust sensorB09 “Filling display left”, refer to
page62.
522044-
Tailgate
Possible cause Remedy
FMI 2: When moving to a position, the current position of the tailgate could not be determined.
The sensors are defective or
have been incorrectly set.
 Check and set the following sensors, refer to page73:
• Sensor B11Lock hook bale chamber left
• Sensor B12Lock hook bale chamber right
There is a mechanical fault at
one of the sensors.
 Contact the KRONE service partner.
522046-
Tailgate
Possible cause Remedy
FMI 7: The tailgate could not be closed within the specified time.
The sensor is defective or has
been incorrectly set.
 Check and set the sensorsB11/B12 "Lock hook bale
chamber left/Lock hook bale chamber right", refer to
page73.
The tailgate blocks mechanic-
ally.
 Remove the blockage, e.g. crops.
The stop cock tailgate locks
the hydraulics.
 Open the stop cock tailgate, see chapter Safety, “Stop cock
tailgate”.
The hydraulic pressure is in-
sufficient.
 Check whether the rotational speed of the universal shaft is
sufficient and increase it, if necessary.
522047-
Tailgate
Possible cause Remedy
FMI 2: The tailgate is open while starting up the machine.
The tailgate is not locked.
 Close the tailgate using the tractor hydraulics.
The sensor is defective or has
been incorrectly set.
 Check and set the sensorsB11/B12 “Lock hook bale
chamber left/Lock hook bale chamber right”, refer to
page59.
522048-
Tailgate