8 Terminal error messages
8.1 Faults of the electrics/electronics
90
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en
Possible cause Remedy
FMI 2: – The tailgate is open during road operating mode.
The tailgate is not locked.
Close the tailgate using the tractor hydraulics.
The sensor is defective or has
been incorrectly set.
Check and set the sensorsB11/B12 “Lock hook bale
chamber left/Lock hook bale chamber right”, refer to
page73.
522049-
Tailgate
Possible cause Remedy
FMI 2: An open tailgate was detected, although no tying has occurred since it was last closed.
The baling pressure is too
high.
Start net or chamber film wrapping in manual operation and
have the round bale tied, refer to page50.
The bale chamber is overfilled
and it was thus opened by the
round bale.
Manually empty the bale chamber:
The tailgate is not correctly
locked.
Open and close the tailgate again.
522101-
SensorB01 “Speed of bale chamber”
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally.
Check sensor and wiring for damage, refer to page73.
The sensor wiring is faulty.
522102-
SensorB02 “Tying process active”
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally.
Check sensor and wiring for damage, refer to page73.
The sensor wiring is faulty.
522105-
SensorB05 “Slip floor conveyor”
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally.
Check sensor and wiring for damage, refer to page73.
The sensor wiring is faulty.
522106-
SensorB06 "Twine tying cycle active"
To Next Page
Loading...
