Krone Comprima V 150 - Page 378

8 Terminal error messages
8.1 Faults of the electrics/electronics
96
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en
Possible cause Remedy
FMI 5: There is a cable break, general error or overload.
FMI 6: There is a short circuit to ground or amperage is too high.
The actuator is damaged ex-
ternally.
 Check actuator and wiring for damage, refer to page73.
The wiring of the actuator is
faulty.
522500-
EEPROM
Possible cause Remedy
FMI 13: The wrong configuration values were saved.
An invalid machine type has
been specified.
 Adjust the machine type.
 Restart the machine.
The configuration parameters
of the machine are invalid.
 Configure the machine correctly.
 Restart the machine.
522530-
KMB1
Possible cause Remedy
FMI 31: The condition has been fulfilled.
The wiring is faulty.
 Check wiring.
The control unit is defective.
 Note the error number and the FMI. Then contact the
dealer.
522531-
KMB1
Possible cause Remedy
FMI 19: There is a network/CAN error.
The wiring is faulty.
 Check wiring.
The control unit is defective.
 Note the error number and the FMI. Then contact the
dealer.
522532-
KMB2
Possible cause Remedy
FMI 31: The condition has been fulfilled.
The wiring is faulty.
 Check wiring.
The control unit is defective.
 Note the error number and the FMI. Then contact the
dealer.
522533-
KMB2