Safety
17
Pos: 13.6.16 /B A/Sicherheit/Wartu ng/Wartung Mä her mit Gassp eicher+ Aus wechseln von Arbeits werkzeug en@ 0\mod_119 5647075607_ 78.docx @ 1442 @ 2 @ 1
4.8 Maintenance
1 Always make certain that the drive and the engine are switched off before doing any
repairs, maintenance or cleaning! - Remove the ignition key!
2 Regularly check that nuts and bolts are properly seated and tighten if necessary!
3 When carrying out maintenance work on a raised mowing unit, always use suitable
means to secure it against falling.
4 When replacing working tools with cutting edges, use suitable tools and gloves!
5 Oils, greases and filters must be disposed of correctly!
6 Always disconnect the power supply before working on the electrical system!
7 If protective devices and guards are subject to wear, check them regularly and replace
them in good time!
8 When performing electrical welding work on the vehicle and mounted devices, turn the
power supply off at main battery switch or disconnect generator cable and battery!
9 Replacement parts must at least comply with the technical requirements set by the
manufacturer of the implements! This is guaranteed by original KRONE spare parts!
10 Only use nitrogen for filling pneumatic accumulators - risk of explosion!
Pos: 13.6.17 /B A/Sicherheit/Wartu ng/Wartung Z usatz bei Gass peicherung @ 3 8\mod_12657 87178167_78.d ocx @ 349311 @ @ 1
11 Repairs to pretensioned energy stores (springs, accumulators, etc.) require adequate
knowledge and correct assembly tools and may be performed in specialist workshops
only!
Pos: 13.6.18 /B A/-------- -------Seitenumbruch--- --------- ---- @0\ mod_11961753 11226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
