Krone EasyCut 3600 CV - Adjusting the Tedder Speed

Settings
52
Pos: 24.22 /Übersc hriften/Überschrif ten 2/A-E/Ein stellung der Z etterdrehzahl @ 0 \mod_1196 668564463_78. docx @ 10266 @ 2 @ 1
9.5 Adjusting the Tedder Speed
Pos: 24.23 /BA/Sic herheit/Gefahre nhinweise/Ei nstellarbeiten / Ei nstellungen/ Gefahr - Einstellung en an der M aschine @ 0\ mod_11966686 28056_78.doc x@ 10285 @ 3 @ 1
Danger! - Settings on the machine
Effect: Danger to life, injuries or damage to the machine.
• Setting tasks must only be performed when the drive is switched off and the engine is at
a standstill! Remove the ignition key!
Pos: 24.24 /BA/Ei nstellungen/M ähwerke/Zetterdr ehzahl/Zetterdr ehzahl Bild EC 2800/3200 @ 1 0\mod_12222 64227671_78.d ocx @ 139507 @ @ 1
EC-0-031_2
900
600
Figure 29
Pos: 24.25 /BA/Ei nstellungen/M ähwerke/Zetterdr ehzahl/Zetterdr ehzahl einstell en 600/900 @ 11\mod_122361 3453645_78.doc x @ 148195 @ @ 1
Two tedder speeds can be set on the speed gearbox. This affects the conditioning effect and
the power consumption.
Minimum speed: 600 rpm.
Maximum speed: 900 rpm.
• Unscrew the wing screw (1) from the actuating lever (2).
• Rotate the actuating lever (2) 180°. In doing so, turn the mower drum (3) so that the
actuating lever can be rotated completely.
• Secure the actuating lever (2) with the wing screw (1).
Pos: 24.26 /BA/--- ------ ------Seitenumbruch---- ------------ @ 0\m od_1196175311 226_0.docx @ 4 165 @ @ 1