Krone EasyCut F 280 - Page 91

Special equipment
91
• Mount the cutting discs (5) and covers (6). To do this, reuse the fastening bolts and detent
edged washers of the mower drums that were removed.
Note
Follow the steps in the reverse order for reinstallation (see also Chapter "Conversion to
Narrower Swathing").
Before starting up the machine again, make certain to check the cutter blades, retaining bolts,
cutting discs, and drums as well as the linings
• See Maintenance section "Checking the Cutter Blades and Retaining Bolts".
• See Maintenance section "Periodical Inspection of Cutting Discs and Drums."
• See Maintenance section "Replacing the Linings".
Pos: 149 /Layou t Module /---------------Seitenumbruch---------------- @ 0\mod_11961753 11226_0.docx @ 4165 @ @ 1