Krone EasyCut F 280 - Page 94

94
Personnel Qualification and Training .................. 11
Placing in Storage ............................................... 84
Position of the Adhesive Safety Stickers on the
Machine .......................................................... 20
Preparation on the front-mounted disc mower ... 34
PTO operation .................................................... 14
PTO shaft ............................................................ 40
Purpose of Use ................................................... 10
R
Removing the compensation spring(s) ............... 50
Re-Ordering the Adhesive Safety and Information
Labels ............................................................. 19
Re-Ordering this Document .................................. 6
Replacing the linings ........................................... 81
Rotary hub with shear fuse (optional) ................. 58
S
Safety .................................................................. 10
Safety Instructions and Accident Prevention
Regulations ..................................................... 12
Safety-conscious work practices ........................ 11
Scope of Document .............................................. 7
Service life of the machine ................................. 10
Setting of the V-belt Tension ............................. 65
Settings .............................................................. 51
Spare Parts ........................................................ 54
Special equipment ............................................. 87
Start-up .............................................................. 36
T
Target group of this document ............................. 6
Technical data .................................................... 24
Technical data dimensions .. 24, 25, 26, 27, 28, 29
Technical data minimum tractor requirements . 24,
25, 26, 27, 28, 29
Technical Data of the Machine .......................... 24
Telescopic upper suspension arm ..................... 52
Term ..................................................................... 7
Test run .............................................................. 85
Test run .............................................................. 54
Tightening torques ............................................. 56
U
Unauthorised Conversion/Modification and Spare
Parts Production ............................................ 15