Krone EasyCut F 320 M - Preparing for Road Travel

Driving and Transport 9
Preparing machine for road travel 9.1
EasyCut F 320 M
Original Operating Instructions 150000808_01_en 51
9.1 Preparing machine for road travel
KMG000-057
ü All points listed in the chapter "Start-up" have been fulfilled, refer to page38.
ü The machine is shut down and safeguarded, refer to page24.
ü For "Hydraulically foldable side guards" version: The hydraulic hoses are connected,
refer to page42.
ü For "Hydraulically foldable side guards" version: The side guards(1) are folded up refer
to page47.
ü The universal shaft has been installed, refer to page43.
ü Depending on the national regulations: The lighting is connected and functional, refer to
page42.
ü Depending on the national regulations: The lost load centre has been checked, refer to
page44.
ü The mower was lifted into the transport position via the front hydraulics, refer to page49.
ü The front hydraulics have been blocked, e.g. via a stop cock.
9.2 Switching off the machine
3
2
1
5
6
7
KMG000-019