A - 2
Appendix
A1.4 Attaching the warning signs
Warning signs (1) unit are ready installed.
Fix warning signs unit with hex. bolts and plain washers
(2) to the chassis.
A1.5 Installing the lighting system
The connecting cable from the socket to the rear lights
has already been installed in the chassis ex-works.
Install the cable plug connector from the rear lights in
the centre of the warning signs board so that these are
visible from the rear. Complete installation of clearance
lamps inclusive of support plate.
Check fixed link. Push cable back into the chassis
frame.
Check the lighting for proper functioning.
1
SW700019
1
SW700020
2
SW700032
To Next Page
Loading...
