-A17-
(2) The strap can not be cut completely
a. The sealing time might be set too short.
b. The strap is not thread correctly so a small part of the strap is not cut completely.
c. The Cutter (H46-40900) is worn.
(3) Error Code
E01：M1 over load.
E02：M2 cannot back to home position.
The SQ1 sensor could be damaged or the connection is loose.
E04：M2 over load.
The strap could be too thick or the H46-40200 Swivel Bracket is not moving smoothly.
E05：PCB overheats.
The tool needs stop working until the PCB cool down to normal temperature.
E07：M1 cannot run.
The wire connection of M1 could be loose or the mechanism is stuck.
To Next Page
