-A16-
Strap Stop touches the straps
DISPOSAL
The power tool, accessories and packaging materials should be sorted for
environmental-friendly recycling.
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/EC for Waste Electrical and
Electronic Equipment and its implementation into national right, power
tools that are no longer usable must be collected separately and disposed
of in an environmentally correct manner.
7. Troubleshooting
(1) The strap slips while tensioning
a. Tension force setting is higher than the Strap Strength. Please reduce the tension (refer
to Page no.8 in Part I of Manual).
b. There is too much strap debris on the teeth of the Tensioning Wheel
(H46-10700/H46-10710) or Gripper (H46-10900)
c. Strap Stop (H46-10600 /H46-10610) touches the straps. (shown as following
drawing). Please clean the Tensioning Wheel (H46-10700/H46-10710) and feed the
strap appropriately until the Strap Stop won’t affect the strap while tension.
d. The Tensioning Wheel (H46-10700/H46-10710) or Gripper (H46-10900) teeth is worn
and need replacement.
To Next Page
Loading...
