8
Simply open the lid and lift up the keg for approximately
5-10 seconds before setting back into the machine and
closing the lid.
* After setting up the BeerTender and before use, it is
vital to clean the detachable pour spout – this is the
only part of the appliance that will come into contact
with the beer. The spout should be rinsed by hand.
After cleaning, screw back into place.
* Before inserting the DraughtKeg into the BeerTender,
simply snap the patented disposable draught beer
tube (included) onto the DraughtKeg.
* Open the BeerTender cover by pressing in the release
panel on the front of the machine.
* Open the tap spout cover by turning counter
clockwise.
* Insert DraughtKeg into BeerTender and position the
draught beer tube as shown on drawing.
* Close the tap by turning clockwise and snapping into
place.
* Carefully close the lid.
* Set the drip tray and grate in place at the front of the
appliance. Make sure the drip tray is properly fitted
and positioned.
WARNING! The drip tray must be positioned on a level
surface and must not jut out from the surface it is resting
on.
Control Panel
* Press the “C” button on the lefthand side of the display
panel. This resets the 30 day calendar and will
countdown from the day you reset with each new
Draughtkeg.
To Next Page
Loading...
Need help?
General
