Need help?Do you have a question about the KSB Etabloc and is the answer not in the manual?
General| Pump Type | Centrifugal Pump |
|---|---|
| Pressure | Up to 16 bar |
| Material | Cast iron, Stainless steel |
| Impeller Type | Closed impeller |
| Design | Close-coupled |
| Temperature Range | -10°C to +140°C |
| Shaft Seal | Mechanical seal |
| Motor Type | IE3 efficiency |
| Speed | 1450 rpm, 2900 rpm |
| Connection | Flanged |
| Standard | EN 733 |
| Applications | Water supply, industrial applications |
Specifies requirements for personnel involved in unit operation and maintenance.
Details safety guidelines for operators, maintenance, and consequences of non-compliance.
Details proper handling and securing during transport to prevent injury/damage.
Guidelines for storing the unit to prevent corrosion and maintain condition.
Describes the product's application, identification, and design details.
Details pump construction and noise levels.
Covers safety, hazardous locations, and prerequisites before installation.
Describes mounting, alignment, and foundation requirements.
Guidelines for connecting pipelines, strainers, and auxiliary lines.
Instructions for electrical connection, motor wiring, and rotation checks.
Lists prerequisites, start-up steps, and safety checks.
Steps for safely shutting down the pump, including draining.
Defines operational boundaries for temperature, switching frequency, flow, and density.
Procedures for temporary and long-term shutdowns and storage.
General rules for maintenance personnel and routine servicing.
Specifies grease type, quantity, and change intervals for bearings.
General instructions and safety for dismantling the pump.
Rules for reassembling pump components and the mechanical seal.
Table of tightening torques for various bolted connections.
How to order parts and recommended stock levels.
Table of common problems, their causes, and remedies.
Illustrates various installation orientations for Etabloc G and N models.
To Next Page
