Need help?Do you have a question about the KSB Etanorm SYT and is the answer not in the manual?
General| Drive | Electric motor |
|---|---|
| Pump type | Centrifugal pump |
| Application | Water supply, irrigation |
| Operating pressure | Up to 16 bar |
| Fluid temperature | Up to 120°C |
| Temperature range | -10 °C to +140 °C (depending on material and seal) |
| Casing material | Cast iron, stainless steel |
| Impeller material | Bronze, stainless steel |
| Shaft seal | Mechanical seal |
| Connection | Flange |
| Size range | DN 32 to DN 300 |
| Material | Cast iron, stainless steel, bronze |
Manual purpose, target audience, principles, and reference to other documents.
Explains symbols used in the manual and defines safety symbols and their meanings.
General safety instructions, intended use, and personnel qualification requirements.
Outlines risks of non-compliance, general safety awareness, and operator/maintenance safety.
Information on explosion protection, marking, temperature limits, monitoring, and operating limits.
Instructions for checking pump condition upon delivery and safe transport methods.
Recommendations for storing the pump, procedures for returning it, and disposal guidelines.
Pump overview, product info, and designation system explanation.
Name plate details, design features, configuration, function, and noise characteristics.
Data on noise levels, dimensions, weights, and scope of supply.
Pre-installation checks, pump set installation (on foundation/without foundation).
Connecting piping, permissible forces, vacuum balance lines, and auxiliary connections.
Enclosure, coupling alignment, motor alignment, electrical connection, and rotation checks.
Prerequisites, priming, venting, final checks, and start-up instructions for the pump set.
Shaft seal checks, shutdown procedures, and operating limits including fluid handling.
Procedures for pump shutdown, storage, preservation, and returning to service.
Safety regulations for servicing/maintenance and general servicing/inspection procedures.
Tasks for inspection, lubrication of bearings, and filter cleaning.
Procedures for dismantling, removing components, and reassembling the pump set.
Torque specifications for pump/set connections and spare parts management.
Table listing common pump faults, their possible causes, and recommended remedies.
Exploded views and component lists for various Etanorm SYT bearing bracket configurations.
Examples of mechanical seal connections and spare parts information.
Declares conformity of the product with relevant EU directives and standards.
A form for certifying the decontamination status of the product.
To Next Page
