Need help?Do you have a question about the KSB Etanorm and is the answer not in the manual?
General| Material | Cast iron, bronze, stainless steel |
|---|---|
| Applications | Water supply, irrigation, heating |
| Shaft Seal | Mechanical seal |
| Speed | 1450 rpm, 2900 rpm |
| Size Range | DN 32 to DN 300 |
Describes the manual's purpose and safe use of equipment.
Lists other relevant documents for pump installation and operation.
Explains symbols used throughout the manual for guidance and warnings.
Defines hazard symbols and signal words for risk identification.
Specifies correct usage and prohibited operations for pump safety.
Outlines requirements for personnel involved in pump installation and operation.
Provides essential safety advice for operators regarding maintenance and handling.
Details specific safety requirements for operation in potentially explosive atmospheres.
Instructions for safe handling and transportation of the pump set.
Recommendations for protecting the pump during storage.
Procedures for returning the pump and environmentally sound disposal.
Overview of the pump's construction and application.
Explains pump identification codes and information on the nameplate.
Detailed breakdown of the pump's mechanical design and operational principle.
Provides sound pressure levels for the pump at different operating speeds.
Information on the physical size and mass of the pump set.
Critical safety rules to follow during installation.
Steps to verify the installation site and foundation requirements.
Step-by-step guide for physically installing the pump set.
Guidelines for connecting pipelines to the pump, including forces and moments.
Requirements for installing protective guards for safe operation.
Detailed steps for aligning the pump and motor couplings.
Instructions and safety warnings for electrical hook-up.
Method for verifying the correct rotational direction of the pump.
Prerequisites and steps for safely starting the pump set.
Specifies operating parameters and conditions to maintain.
Instructions for safely shutting down and preserving the pump.
Steps to prepare a stored pump for re-commissioning.
Safety regulations to be observed during all maintenance activities.
Routine checks and inspections for pump health.
Details on oil and grease lubrication for bearings, including intervals and quality.
Procedures for safely disassembling the pump set components.
Step-by-step instructions for putting the pump set back together.
Torque values for essential screwed connections during assembly.
Guidance on stocking essential spare parts for maintenance.
Table of common faults, possible causes, and remedies for pump operation.
Visual diagrams and part numbers for pump components.
To Next Page
