Why KTM 1290 Super Adventure S 2018 Motorcycle engine turns but does not start?
If your KTM Motorcycle engine turns but doesn't start, there could be a few potential issues. First, ensure that the plug-in connection of the fuel hose is properly connected. Second, there might be a fault in the fuel injection system. Third, the fuel quality might be insufficient, so try adding suitable fuel.
What to do if KTM 1290 Super Adventure S 2018 Motorcycle engine does not turn if the emergency OFF switch/electric starter button is pressed?
If your KTM Motorcycle engine doesn't turn when you press the emergency OFF switch/electric starter button into the lower position, consider these potential causes. It could be an operating error, so ensure you are following the correct start procedure. Also, the battery may be discharged, so recharge it and check the open-circuit current. It is also possible that the safety start system is faulty or there is an electronic fault.
Why does KTM Motorcycle engine die during the trip?
If your KTM Motorcycle engine dies during a trip, it might be due to a lack of fuel, so refuel. Alternatively, there could be a fault in the fuel injection system.
Why does KTM 1290 Super Adventure S 2018 have high oil consumption?
High oil consumption in your KTM Motorcycle can be attributed to a couple of factors. The engine oil level might be too high, so check it. Alternatively, the engine oil might be too thin (low viscosity), in which case you should change the engine oil and oil filter and clean the oil screens.
What to do if the combination instrument shows nothing on the KTM 1290 Super Adventure S 2018 Motorcycle display?
If the combination instrument on your KTM Motorcycle display is blank, there could be several reasons. First, check if Fuse 1 is blown and replace it if necessary. Second, the main fuse might be burned out, so replace that as well. Finally, the battery could be discharged; in this case, recharge the battery and check the open-circuit current.
Why does the ABS indicator lamp light up on KTM 1290 Super Adventure S 2018?
If the ABS indicator lamp lights up on your KTM Motorcycle, it could be due to several reasons. First, the ABS fuse might be blown, so replace the fuses in the fuse box. Second, the wheel speeds of the front and rear wheels may differ greatly; in this case, stop, switch off the ignition, and start again.
What causes the battery to discharge on a KTM Motorcycle?
If the battery of your KTM Motorcycle is discharged, consider these possible causes: a power consumer might be connected to the socket/ACC1, so disconnect it and recharge the battery; the hazard warning flasher might be switched on, so switch it off and recharge the battery; the battery may not be charged by the alternator, so check the charging voltage; or the ignition was not switched off when the vehicle was parked, so recharge the battery.
What does it mean if the malfunction indicator lamp lights up on KTM 1290 Super Adventure S 2018?
If the malfunction indicator lamp lights up on your KTM Motorcycle, it indicates a potential fault in the fuel injection system.
What does it mean if Race-on indicator lamp flashes twice on KTM Motorcycle?
If the Race-on indicator lamp flashes twice on your KTM Motorcycle, it means there is no response signal from the Race-on key. Make sure the Race-on key is within range, remove other electronic devices from the vicinity of the Race-on antenna, check the battery compartment in the Race-on key for correct locking, check the battery holder of the Race-on key for corrosion. You can also try changing the Race-on key battery or using the black ignition key.
Why does KTM 1290 Super Adventure S 2018 Motorcycle engine turn only if the clutch lever is drawn?
If the KTM Motorcycle engine turns only when the clutch lever is drawn, it could be because the vehicle is in gear, so shift the transmission to idle.
General| Engine Type | 2-cylinder, 4-stroke, V 75° |
|---|---|
| Displacement | 1301 cc |
| Transmission | 6-speed |
| Final Drive | Chain |
| Front Suspension | WP semi-active suspension USD Ø 48 mm |
| Rear Suspension | WP semi-active suspension monoshock |
| Wheelbase | 1560 mm |
| Fuel Capacity | 23 liters |
| Dry Weight | 215 kg |
| Power | 160 hp (118 kW) @ 8750 rpm |
| Torque | 140 Nm @ 6750 rpm |
| Front Brake | 2 x 320 mm discs, 4-piston calipers |
| Rear Brake | 267 mm disc, 2-piston caliper |
| ABS | Bosch 9ME Combined ABS |
| Traction Control | MTC (Motorcycle Traction Control) |
| Seat Height | 860/875 mm |
| Tires Front | 120/70 R19 |
| Tires Rear | 170/60 R17 |
To Next Page
